Bathtubs
Porcelain over steel, cast iron, fiberglass and acrylic. Stripped to a clean substrate, chips and rust filled, then sprayed to a uniform gloss.
Bathtub refinishing and repair. Metro Atlanta and beyond.
Bathtub refinishing and repair. Metro Atlanta and beyond. Also called reglazing or resurfacing — we restore the surface of the fixture you already have, in a single visit, for a fraction of the cost of replacing it.
Before
The work
Nothing below was torn out and replaced. Every photograph is a Bathman Refinishing job — the original fixture, stripped, repaired and re-coated where it stood.
Stained, worn treads brought back to a uniform white. Shot from the same spot before and after — drag to sweep between them.
Each pair below is a single fixture: the same tub, pool or step unit photographed before Bathman Refinishing started, and again once the new coating had cured. Tap any photo to open it full size.
Baptistry shell and steps taken from mint green back to white, re-coated in place with the surround masked.
Rust staining and surface cracking taken back to an even white.
Chalked, patchy gel coat re-coated to one even surface.
Worn non-slip pads and rust flecks taken back to an even white.
Spot work — the chip filled and blended, the rest of the tub left alone.
A broken corner rebuilt, then the step and bench re-coated. Structural damage is repaired before anything is sprayed.
A split deck around a corroded faucet, and the same deck with the stems pulled and the damage cut back, ready for filling.
A whole moulded baptistry — shell, steps and floor — taken from worn green back to an even gloss white, re-coated where it stood.
Reviews
Customers on Yelp keep returning to the same three things: he arrives when he said he would, he protects the room he's working in, and he holds the price he quoted. The reviews below are hosted on Yelp, not collected here — we can't edit, filter or reorder them.
—out of 5Incredible job. My garden tub looks new. Robert took great care in taping off and covering everything, including in the bedroom. I highly recommend Robert Gabelli.
Great communication, price, and knowledge of refinishing. Very satisfied with the end product and more importantly the service that was provided. Hard to find quality workmanship like this anymore.
Bathman Refinishing did a superb job!! Out 1963 cast iron bath looks brand new. …
Robert made my shower feel new again! He is so accommodating to work around my schedule and the result is unbelievable. He is very honest and charged me less than initially he estimated after he came and saw my bathroom.
Robert is very professional and experienced in what he does. His work is attentive to detail and well done. He's very organized in the process of working and cleans up well after he left. …
Read every review on Yelp® Reviews and ratings are the property of Yelp Inc. and its users. Yelp® is a registered trademark of Yelp Inc. Bathman Refinishing does not host, moderate or curate them.
What is refinishing?
Bathtub refinishing — also called reglazing or resurfacing — restores the surface of the tub you already have instead of removing it. Bathman Refinishing cleans the old finish, repairs the damage underneath, then sprays on a new bonded coating. Most tubs we're called to in Metro Atlanta are structurally sound; what's failed is the glaze, the grout, and the color someone chose in 1994.
After 40 years across this metro, the pattern is familiar: the tubs we refinish in Decatur and East Atlanta bungalows are mostly 1920s–1950s cast iron under porcelain enamel, while out in Gwinnett and Cherokee subdivisions it's nearly all 1990s–2000s fiberglass tub-and-shower units. They need different preparation, and knowing which you have before we arrive is half the job.
Refinish or replace?
Refinish if the tub is sound but stained, scratched, chipped or an outdated color. Replace it if it's cracked through, leaking, structurally soft, or if you're moving plumbing or converting to a walk-in shower — refinishing is a surface restoration, not a structural repair. Bathman Refinishing will tell you which one you're looking at.
Porcelain over steel, cast iron, fiberglass and acrylic. Stripped to a clean substrate, chips and rust filled, then sprayed to a uniform gloss.
Pink, almond, avocado, blue — dated wall tile refinished in place along with its grout lines, so the whole surround reads as one clean sealed surface instead of a grid of stains.
Spot work when the whole surface doesn't need doing: a chipped rim, a rust ring at the drain, cracks in fiberglass, holes left where old hardware came off.
The same trade, scaled up. Faded and chalked fiberglass pool shells, church baptistries and baptismal pools, and the moulded step units that stain and crack first — stripped, repaired and re-coated in place.
Service area
Bathman Refinishing serves Metro Atlanta — Fulton, DeKalb, Cobb, Gwinnett, Clayton, Cherokee, Henry, Douglas, Fayette and Rockdale counties, roughly within 40 miles of downtown. This is a mobile trade: the work happens in your bathroom, so there's no showroom to visit and nothing to transport.
Not on the list? Call and ask — the list isn't the boundary. Metro Atlanta is the day-to-day service area, but Bathman Refinishing travels for larger jobs: the East Coast and the Midwest, as far west as Texas.
Questions
Bathtub refinishing restores the surface of the tub you already have instead of removing it. The old finish is cleaned and prepared, chips, cracks and rust are filled, and a new coating is sprayed on and cured — usually in a single visit. The fixture, the plumbing and the surrounding tile all stay where they are.
Nothing — they are three names for the same job. Refinishing describes the whole restoration: cleaning, repair, preparation and coating. Reglazing strictly names the final coating step, and resurfacing is the term used more often for pools and spas. Homeowners and contractors use all three interchangeably, so ask for whichever term you know.
A professionally refinished bathtub typically lasts 10 to 15 years. Lifespan depends heavily on how it's cleaned. The two most common causes of early wear are powdered abrasive cleansers and suction-cup bath mats, which trap water against the finish.
Nationally, refinishing a standard bathtub runs roughly $300 to $600, while replacing one runs roughly $1,500 to $8,000 once you include demolition, disposal, the new fixture, plumbing, tile and labor. Refinishing commonly costs up to 75% less.
Your price depends on the size and material of the fixture and its condition. Call for a firm number on your bathroom — we don't quote sight-unseen.
2026 national averages published by HomeGuide, Angi and This Old House — not Bathman Refinishing's pricing.
Most refinished tubs can be used again 24 to 48 hours after spraying. The coating keeps hardening for about 7 days, so keep bath mats, suction cups and cleaning products off it for the first week.
Peeling is a preparation failure, not a property of refinishing. It happens when the old surface wasn't fully cleaned, prepared and primed — which is exactly what consumer DIY kits can't do properly. A correctly prepped and sprayed surface bonds to the substrate and stays put.
There's a noticeable odor while the coating is sprayed and while it cures, and we'd rather tell you up front. The bathroom is ventilated during the work, technicians wear respirators, and the smell typically clears within about 24 hours. Keeping a window open and the bathroom door shut speeds it up.
On safety: under the EPA's 2024 rule through the Toxic Substances Control Act, methylene chloride is banned as a commercial bathtub stripper. Professional refinishers now use methylene-chloride-free stripping and coating systems.
They cost far less up front and they're the reason refinishing has a reputation for peeling. A kit applies a thin single-part coating — roughly 2 to 3 mils once cured — over a surface most homeowners can't properly strip or prepare. That's why kit finishes commonly fail within months to a couple of years.
The part people don't expect: stripping a failed kit coating adds cost to the professional job afterward.
Replace it if the tub is cracked through, leaking, or structurally soft underfoot, or if you're changing the bathroom layout or converting the tub to a walk-in shower. Refinishing renews a sound tub that's stained, scratched, chipped or dated — it does not repair structural failure, and we'll say so rather than sell you a finish that sits on a bad tub.
Yes. Bathman Refinishing works with landlords and property managers across Metro Atlanta on single units and multi-unit turnovers. Refinishing returns a unit to rentable condition in a day instead of taking the bathroom out of service for a week, which is usually the deciding factor between turns.
Yes. Chips, cracks, rust rings around the drain and overflow, and holes left by removed hardware can be repaired as spot work when the rest of the surface is fine. If the damage is widespread, refinishing the whole fixture usually costs less than repeated spot repairs.
Yes. Wall tile and its grout can be refinished in place to a single sealed color without opening the wall. This is the standard fix for pink, almond, blue or avocado tile that's structurally sound but dated.
Non-abrasive liquid cleaner and a soft cloth or sponge. Avoid powdered abrasives, scouring pads, bleach-heavy products and anything with ammonia. Skip suction-cup mats entirely — use a mat with a smooth backing if you need one.
The promise
Quality workmanship at an affordable price.
Robert Gabelli forty years in the trade
Great communication, price, and knowledge of refinishing. Very satisfied with the end product and more importantly the service that was provided. Hard to find quality workmanship like this anymore.
Free quote
The fastest way to a price is a picture. Attach a photo of the tub, tile or pool below — or text one to 678-BATHMAN (678-228-4626) — and we'll tell you what it takes. If replacing is the better call, we'll say that too.